GETTING STARTED WITH PIMAG WATERFALL

Here is through this article the installation of the Pimag Waterfall.
The installation is really simple, you will find the detailed steps below.

1 / REMOVE THE DIFFERENT PACKAGING PLASTICS IN THE PIMAG WATERFALL

You will receive your Pimag Waterfall in a box like this.

2/ Rinsing

Rinse the 2 water collection containers. Blue colored containers.

Important: Rinse the stones as well.

This is because there is a slight residue in the stones when you take them out of the plastic. This is normal in the composition of the stones, but you must rinse them before installing them in the bottom compartment. Take the time to rinse them well.

3/ Installation

3.1 Then position the bottom tank on the base. This is the reservoir that contains the faucet.

3.2 Place the stones rinsed beforehand in this tank.

Position them all around the faucet and the hole that allows the water to drain (see below).

Then place the collecting tank with the plastic junction element which makes it possible to make the connection between the 2 tanks.
The holes should be placed towards the rear of the Pimag (here right side). Subsequently allowing the filter to be housed.

4/ Installation of the filter

There is an important step here to perform so that there is a good seal between the 2 tanks. So that water only passes through the interior of the filter.

You simply have to position the joint strip (purple in color) on its lower part as in the photo below.

Once the seal is properly positioned place it in the top tank.
Place it evenly. That is, when you press down to push it in properly, apply pressure with your fingers all over the top at the same time.

I made a short video to make it easier to understand.

5/ End of installation

After installing the filter, your Pimag Waterfall is now ready. You can put the cover on the top of the fountain. The opening of the cover should be on the front.

6 / First use

When you go to fill your water collection container at the top, the first filtration will take longer. The time it takes for water to pass through the filter for the first time. It takes around 30 to 45 minutes. The following filtrations will be much faster to use you will see.

Place your Pimag in a passageway where you can quickly fill in as needed.
To fill the top tank completely, you need 3 to 4 pitchers of water. Depending of course on the capacity of your pitcher.

Personally, for daily use, it is very robust, both for containers and for the tap.
And there are also pads underneath the plinth to keep it from slipping.
It is easy to use.

Last element to take into account:
If during the first use there are residues on the lower part on the surface of the water, it is nothing, it is the stones. You can just empty the tank to remove the last residue.

Advice :

The filter should be changed every 3 to 6 months for optimal use.
The stones are to be replaced once a year.

If you would like more information, please do not hesitate to contact me.
sylvain.nikken@gmail.com